Agtec Telecoms - Fibreflow Push Fit Connectors MHT860E

Materials:
BODY: acetal copolymer, impact resistant; some are transparent.
COLLET: acetal copolymer, stainless steel teeth
O-RINGS: nitrile rubber

PERFORMANCE: (data implies nylon tube to BS 5409 unless otherwise stated)

	•SIZES
•temperature	•up to 8mm	•0mm and over
•-10°C to +40°C	•16 bar	•10 bar
•+40°C to +65°C	•10 bar	•7 bar

Burst pressure rated (all sizes) 25 bar min.

(No connector is expected to burst below
30 bar on a clean PE tube.)

Leakage at 8 bar gas pressure: 1ml/minute approx
Leakage at 0.7 bar gas pressure: 0.01ml/minute approx

3. Insertion force:
50N max (5kg)

4. Retention force:
25N min (3mm tube)
55N min (5mm tube)
125N min (8mm tube)
125N min (10mm tube)

This data sheet is intended as a guide only. Whilst the information it contains is believed to be correct, Agtec can take no responsibility for actions taken based on the information contained in this document. Agtec Ireland reserves the right to make changes to this document without notice. All sales of product are subject to Agtec's terms and conditions of sales only. This document is protected by copyright © Agtec Ireland Limited 2009. The products depicted are protected by intellectual property rights. Any unauthorized copying of this document or of our products is prohibited and Agtec Ireland Limited will take action to prevent any infringement of its rights and to claim damage for the loss that it suffers.

Details of the common straight connector, end cap, size-change connector. Other products with similar performance are also available, eg, water-block, gas-block, closedowns, guaranteed seal, bulkhead, etc.

Easy-to-use push fittings ideally suited to the A system. In sizes to match the tube diameters, the fittings are pushed onto a clean-cut tube end and make a seal with internal O-rings. If the tube is pulled away from the connector, internal teeth and a tapered body cause the tube to be gripped tighter. Removal of the tube is achieved by pressing the collet inwards. Emtelle manuals explain more on connector features and use.

•DIMENSIONS: (all approximate)
•type	•diameter	•length		•type	•diameter	•length
•3mm straight	•9mm	•24.5mm		•8 to 5 reducer	•16mm	•45mm
•P5/3.5mm straight	•12.8mm	•39mm		•10 to 8 reducer
•D5/2.1mm straight	•12.4mm	•40.5mm		•12 to 10 reducer	•23mm	•51mm
•P6mm straight	•15mm	•35mm		•3mm end cap	•9mm	•12.5mm
•A8mm straight	•16mm	•44mm		•5mm end cap	•12.4mm	•16mm
•M10mm straight	•19.6mm	•42mm		•6mm end cap	•15mm	•19mm
•M12mm straight	•22.6mm	•54mm		•8mm end cap	•15mm	•21mm
•S5 to 3mm std reducer	•12mm	•32mm	•	•10mm end cap	•17mm	•26mm
•S5/2.1 to 3/2.1 reducer	•12mm	•32mm	•	•12mm end cap
•(Other connectors are also available)